Application Guide

METAL CONDITIONER® for transmissions

METAL CONDITIONER® is designed for creating special operating conditions for mechanical transmission units and mechanisms, under which high-efficient multilevel system for protection against wear and overloads is formed.

Metal conditioner TURBO

Procedure of treating
Squeeze out the revitalizant into the oil filler neck of gear box, transfer case or differential according to the following chart.
Revitalizing is considered to be complete after 50 operating hours or 930 miles (1,500 km) run.

Note!

Procedure of treating an engine with lubricant capacity of 2 to 10 litres (3 tubes).IMPORTANT! The full treatment means three stage process. You need a set of 3 blisters

Stage 1

Squeeze out the contents of one tube into the lubricant neck of the engine warmed up to the running temperature.
Start the engine and let it idle for no less than 2 minutes.

Instructions on compound application

1. Apply to the fuel, which corresponds to the season.
2. Additional (optional) filtering devices may decrease revitalization efficiency.

To get more information on how to treat parts and mechanisms using XADO - please select the appropriate section below or in the left sidebar.