Anticarbon For Engine

This new product will clean up carbon deposit on the cylinder and piston rings without taking off the engine head.

ANTICARBON is designed for fine cleaning of cylinder-piston group of gasoline and diesel engines (including turbo-charged ones) against any kind of contamination (deposits, coke, varnish, tar).
It is not necessary to change motor oil after application. It is safe for catalyst converters, oxygen sensors, mechanical rubber parts and compressors.

ATTENTION!!!

Avoid getting ANTICARBON onto lacquer coatings!
Cover car fenders and hood with a cleaning rag before application.
In case of getting the product into the eyes or on the skin, wash them with large amounts of water.
FLAMMABLE! Do not store and use near open flame.

Results of application:

• reduced oil consumption;
• improved engine power;
• levelling of cylinder compression;
• lower level of noise while engine operating;
• prevents piston overheating as a result of decrease of heat sink;
• reduced level of СО in exhaust gases of the engine;
• removal of carbonic deposits from the spark-plugs.

Application mode 1:

1. Warm up the engine. It should be warm but not hot.
2. Unscrew plugs (injectors). Disconnect ignition timing sensor, Hall device and commutator.
3. Squeeze one tube into each cylinder through the plug hole.
   Screw the plugs in. Wait for 20 minutes. Unscrew the plugs.
   Cover the plug holes with absorbing fabric to prevent from outcoming dirt.
   Rotate the engine for some seconds with the starter.
4. Place the plugs (injectors) into their position.
5. Start the engine and let it operate at about 3500 rpm during 15 - 20 minutes.

During this time carbon softened remains will be removed through the exhaust system.

Application mode 2:

1. Squeeze 4 tubes into the oil mouth of the warmed up engine on basis of 40 ml of ANTICARBON per 3-5 L of oil.
2. Run at idle for 10 - 15 minutes.
3. Drain oil, change oil filter.